Поиск
Показано записей 1-10 из 19
Экономия энергоресурсов при плавке и термообработке на предприятиях Гомельского региона
(ГГТУ им. П. О. Сухого, 2003)
Опыт утилизации металлической стружки
(БНТУ, 2009)
Расчет процесса нагрева шихты
(БНТУ, 2009)
The original method of calculation of duration of burden heating till predetermined temperature is stated.The results of numerical modeling of nonstationary heating of fixed bed are given. Experimental check ...
Получение чугуна из окалины в ротационных печах
(БНТУ, 2009)
The first positive results of iron production (recycling)of disperse oxide waste in experimental-industrial rocking furnace are presented.
Оптимизация выбора плавильных агрегатов
(БНТУ, 2009)
The problem of optimization of right outfits choice at reconstruction of casthouses is considered. Introduction of the system of rating indices is offered.
Системы очистки выбросов плавильных печей
(БНТУ, 2002)
In the experience there is examined the problem of
clarification of discharge from melting furnaces, there is
being analyzed the existing situation on the most of
Belarussian enterprises and are offered the ways ...
Модернизация действующих плавильных печей
(БНТУ, 2003)
In the article there are examined the possible variants
of modernization of the operating melting furnaces with the
aim of increase of their efficiency, economy and ecological
features.
There are presented the joint ...
Интенсификация тепловой обработки дисперсных материалов
(БНТУ, 2003)
In the article there is presented the original rotary
setting for thermal treatment of dispersed materials, developed
by the specialists of UP “Technolit” and GNTU named
after P.O. Suchoj, providing high-efficient heating ...
Печи ротационного нагрева
(БНТУ, 2003)
In the article there are analyzed the different ways
of thermal treatment and melting of polydisperse
materials and there are presented the developed by
authors original coaxial-cylinder furnace settings,
allowing to ...
Компьютерное моделирование потоков в радиационном рекуператоре
(БНТУ, 2004)
The results of the computer modeling of the air
flood in the circular comer of two-pass radiation
recuperator are presented. Production tests proved the
adequacy of calculations.